This is a genuine Senco replacement part, it is sold individually. The No Mar Pad Contact is attached to end of the Safety assembly to prevent the material that it is being used on from getting marred or dented by the Safety assembly. It is a advisable to have one or two extra pads on hand as they do have a tendency to crack and deteriorate over time. And get lost.
Open the seal kit and lay the parts out separately on a clean towel. Then dismantle the nail gun, laying the old seal and o-rings next to the new ones on the towel. You may have to tap the top of the main housing with a soft mallet to release the cylinder. While you have it apart, it is a good time to clean it inside and out. Start instal
... Read moreling the o-rings and seals, lubing them after they are in their correct place. Install the rest of the new parts where they went. Then simply press the no-mar pad on the safety. Put a few drops of oil in the air inlet, and you should be good to go.
its very easy to simply slide the safety assembly into the hole and guide on either side of the feed throat of the nailer. then you just tighten the screw and its all set. I bought my nailer from a pawn shop and the previous owner had for some reason removed the safety on it as well as the tip. easy fix. great website
Removed the top cap and replaced the seal. Cleaned and oiled the inside. Removed the deflector from the cap and replaced the muffler. Then attached the deflector back on the cap. Then attached the cap to the gun. I also replaced the no mar pad on the safety.
Everything went easy except for the latch, the curve on the latch was to much had to straighten a little, also make sure that if not needing to do, not remove screw from magazine recoil spring, it is not difficult to put back , but can snap back and hit your hand
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP10073490
Manufacturer Part Number: HC0401
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
