Part Location Diagram of FC0247 Senco Stop
See part 18 in the diagram
( Grid squares measure 1x1 inch )

Stop FC0247

Manufactured by:
Senco
ERP Number:
ERP10072438
Part Number:
FC0247
Original Equipment Manufacturer ?
Special Order

Easy 

15 - 30 mins 

(2 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is an authentic replacement part manufactured for use with Senco pneumatic coil nailers. The special stop is commonly used with the trigger valve assembly. This stop is available as an individual replacement part, please see model diagram for associative parts.

Troubleshooting

This part works with the following brands:
  • Senco
This part works with the following products:
  • Nailer

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
  • 5 stars
    1
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

would double feed nails and jam.

fred from CRYSTAL RIVER, Florida

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set
Parts Used:
FC0247
remove snap ring from feed piston housing and clean debris from bore. install new stop and spring. replace snap ring. worked fine.
Did you find this story helpful?
Thank you for voting!

Every third or fourth shot would shoot 2 nails at the same time.

Adam from Port St. Lucie, Florida

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Wrench (Adjustable)
Parts Used:
FC0247
1. Temporarily remove retaining ring KB3205
2. Temporarily remove and clean:
-cap FC0295
-Spring KB4217
-piston FC0248
3. REPLACE rubber stop FC0247!!
4. You might choose to replace seal LB0788
5. You might choose to replace seal LB0056
6. You might have to replace ret ainer KB3206
7. Lubricate all of it with Senco Tribo-Lube for Pneumatic Tools - YB0123
8. Put it all back together=ƒÿü
Did you find this story helpful?
Thank you for voting!
  • 1