Part Location Diagram of 884529 DeWALT O-RING
See part 302 in the diagram
( Grid squares measure 1x1 inch )

O-RING 884529

Manufactured by:
DeWALT
ERP Number:
ERP18987508
Part Number:
884529
Original Equipment Manufacturer ?
  Works with your model  NS100!
Special Order
Minimum Quantity of 2 required

Easy 

15 - 30 mins 

(2 rated repairs) ?
  Works with your model   NS100!

Product Description

?

This is an authentic manufacturer-sourced replacement o-ring, it is specially designed for use with Porter Cable staplers and nailers. It helps to provide an air-tight seal for the end cap, make sure to check appropriate diagrams of your model for the correct location and use of this item. Over time o-rings tend to deteriorate and crack eventually requiring replacement to maintain the proper seal. It is a high-quality component which is made of durable rubber material and it is sold individually.

Troubleshooting

This part works with the following brands:
  • Porter Cable
This part works with the following products:
  • Nailer
Part# 884529 replaces these:
884529, P884529,

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
  • 5 stars
    1
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Nailer would not drive nails and leaked air.

donld from TAMPA, Florida

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Wrench set
Parts Used:
A08106, 884529
Disassemble nailer
Clean parts with mineral spirts
lightly lubricate new seals with silicone grease or oil and install new seals.
Reassemble and test.
Did you find this story helpful?
Thank you for voting!

Dropped the nail gun and broke the end cap

Trevor from Lehigh Acres, Florida

0 of 1 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
Parts Used:
884529, 883858
Unscrewed the broken end cap and removed it and the old o-ring. Then installed the new o-ring and end cap.
Did you find this story helpful?
Thank you for voting!
  • 1