TOOL HOLDER 2609110769

This is for a plunge cut tool. I love this tool. I was happy I was able to replace this part as it is what holds the blade. You will need some type of "puller" to pull this off and press new one on.

Had to cut the old one off with a Dremel cut off wheel. Heated the knew one up and pressed it on then used the tool attachment bolt and washer to press it on.

The part arrived quickly and was very easy to install. I am very pleased.

I think the best part of using erepacement parts was the useful information I found on the website about how to install the new part. It was not a typical repair and was not intuitive.

Excellent service from start to finish,

Right part, good price, quick delivery

The part was correct and worked as designed. The website was easy to navigate and find the correct part. The only problem I had, and it might not be eReplacementParts, was that there was no instructions for installation. I did figure it out. I needed a grinder to get the old part off. The new part was heated with a torch to expand it then placed the ring on the shaft and used the screw used for holding attachments to evenly press the ring into place. it worked without issue. be sure that you align the ring so that your attachment is orientated correctly. I would shop here again without hesitation. MGF