Genuine Dewalt replacement part, this item is sold as a kit. The 153755-01 includes both the upper and lower handle. The part is where the trigger switch fir the Miter Saws shown below is placed. This is also the handle that you raise and lower the blade with, and also pull to make a cut in the material you are cutting.
Remove screws and pay attention to the wiring layout within the handle. Clean parts with an old toothbrush and begin the process of placing the parts in the clean mountings. Remove the screws from the old kerf plates and install new ones. Easy work. Patience.
Take pictures to remember where wires go. Unscrew and remove old handle, Place new handle bottom in place. Put wires and switch where they go, refer to pictures . Screw on top piece of handle.
1. Removed the old handle.
2. Moved the wires out of my way.
3. Put the bottom half on and secured it to the saw.
4. Placed the wires back in proper places, including the trigger switch.
5. Installed the top half of handle with screws.
6. Tested the saw, clicked heels and walked away.
Remove the screws from the old handle set. Remove switch. reinstall switch into handle half. Reinstall handle to saw. Remove the screws from the broken kerf boards. place new kerf boards in table and screw down.
Did you find this story helpful?
Thank you for voting!
The top part of the two piece hand-gripped handle was broken
took the broken handle off. took a cell phone picture of the wiring runs through the handle. removed trigger hold down screw. replaced the bottom half of handle, positioned the switch wires in the wire slots, then positioned the top handle. Note that 3 different sizes of star driver screws are present.
All went well, it was an easy repair.
Thanks to you guys for having the part I needed.
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
3
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
