Shoulder Spacer,.380 738-0372B

I removed the steering shaft nut and gear, installed the hex flange bearing, gear, washer, and nut.

remove starter
install parts on starter
reinstalled starter
started lawn tractor a couple times
c-clip failed making all the starter parts fall off
order new starter motor as the motor shaft was bad

1. Cut hole in floorboard to get to nut. (some mowers have a panel to remove)
2. Raised back end of the mower on a lift.
3. Took off the pulley with 1/2 inch socket on nut and 1/2 inch wrench on bolt. Took off pulley, belt, and hardware,
4. Put on new pulley, shoulder spacer, flange nut and belt at same time.
5. ... Read more Ground down hole in floorboard smooth. Covered with duct tape til figure out permanent cover.
6. Should have adjusted variable speed pedal while idler was apart, but didn\'t think of it at the time.
7. Later will adjust variable speed idler the long way per manual.