This is a replacement screw, also known as a shear pin that is used in several pieces of outdoor power equipment. It is made of metal and is approximately 2 inches in length. It is a hex head screw and is sold individually. This is an OEM part sourced directly from the manufacturer.
The Toro 620 models shear pin are hard to replace. Once you get broken pin out you need to tape in the new bolt so when you turn the rotor to opposite side to but on nut with long nose pliers the bolts won\'t fall out. Long extended sockets needed on both nut and bolt end
Good luck
Snow blower has 2 separate augers attached to the auger shaft by a bolt and locking nut. I used a small piece of electrical tape to hold the bolt in place while I attached the nut from the opposite side of the shaft. Then I used two ratchets to hold one side while tightening other side, donGÇÖt forget to wear gloves.
1.tipped the blower back until handles were on the ground.
2. Rotated the auger shaft by rotating the impeller until the bolt hole in shaft was in a workable position, then pushed out piece of the broken bolt that was in the shaft.
3. Inserted the new bolt from bottom side and started the nut. This is the awkward part because
... Read morethe bolt is within the auger hub. Snugged down the self locking nut.
4. Returned the blower to its normal position. Started engine and tested the auger for proper action. DONE.
5. IMPORTANT: Ordered 2 new bolts and locking nuts from ereplacementparts to have on hand if another bolt shears.
1. Made sure the snowthrower off and had the sparkplug unpluged.
2. Tillted the snowthrower back.
3. Used a 3 1/2 exterior screw to push out the remains of the old pin.
4. Inserted the new pin and nut.
5. Lowered the Snowthorower back to the ground.
6. Attached the spark plug.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_13.gif "Part Location Diagram of 321-10 Toro Screw")
_WW_13.gif "Part Location Diagram of 321-10 Toro Screw")
