Cable, Bail, Hw Prope 7101861MA

Took the new one out of the box measured it make sure it\'s the right size to the old one took the old one off with a pair of pliers put the new one on snapped it in place started the mower and cut the grass

Cut the old throttle cable to make it easier to get off the the mower, unhooked it from the throttle and unhooked it from the throttle hand bar. Attached the the new cables at the two points and snapped the clip into place. Took all of 5 minutes. Super easy!

Took the old bail cable off , and put the new one on, , started right up.

Removed rusted cable replaced with new one . Cut zip ties n tied with new ones

I just replace it just the same way I took out the broken one its was that simple

I needed a replacement cable and no stores in my city had the exact length I needed, no one! I was very disappointed and actually first ordered off of amazon. Big mistake because I had to return the item due to its smaller length. I was grateful to receive the right size and length in the mail from eReplacement parts! Just make notes on h ... Read more ow the old one was connected on both ends, then connect the new on in the same way.

Attached end of cable to motor. Routed cable through existing wire ties. Attached cable end to safety lever. Snapped plastic hold down into place. Added spray lube to cable sleeve.