Rope, Recoil Starter (long Typ 28462-ZL8-631

I watch your how-to video on YouTube.
https://www.youtube.com/watch?v=CLwEklOr_0s

1. Used the socket wrench to remove the starter assembly from the mower.
2. Pull the broken cord all the way out until the starter assembly would go no more and insert the
screw driver in one of the openings to keep it at that place.
3. From the assembly get the knotted end loose pull out slightly.
4. Cut ... Read more the knot off with the knife and from the other end of the cord pull the rope completely out
of the starter assembly.
5. With the new cord thread through the outside hole of the starter assembly and through the
hole in the fly-wheel.
6. Once the cord is through the fly-wheel, tie a knot to that end pull the from the other end of
the cord until the knot is secure in the fly-wheel.
7. Now holding the outside end of the cord remove the screw driver from the starter assembly
and let the fly pull the cord in winding it up on the fly wheel. (Note: You should still have a
long piece of the cord outside the starter assembly.)
8. You can now reattach the starter assembly to the mower with the socket wrench.
9. Thread the end of the cord outside the assembly to the cord-holder on the mowers handle.
10. Finally thread the cord end through the grip-starter and tie a knot or 2 to keep in the grip-
starter.

Pulled the mower out.
Sat down on a short chair
Removed the three nuts holding down the recoil starter
Note: Pull the old rope out, holding it to keep it from recoiling.
Snip off the old rope.
Note: Before you install the new rope, tie a knot in the end, while still holding the recoil from rewinding.
Th ... Read more read one end in the recoil starter.

Removed the cover for the pull rope
Replaced the pull rope making sure the return spring was wound
re-attached cover and added a new grip, old one was broken.
Took about 10 minutes and super easy

I followed the YouTube video provided by eReplacementParts and the rope replacement was a snap! Thank you!