Pulley-roller Cabl 756-04331

Drive belt pulley was the hardest . You have drop the engine pulley off the engine shaft and fan on top of the rear hydrostatic drive . Its especially essential to have a hammer drill to do that . Pre soak both both of them with wd40 . On the fan, remove battery and pull out it\'s box holder, seat also . Front and back pulleys need to be ... Read more removed to install drive belt otherwise you can\'t get belt replaced . Did that also at the same time of steering shaft and pinion gear . Remove steering wheel, plus gas tank. Also under side nut .

It took awhile to do it. You have to get a 5/8 wrench on the back side of the frame to hold the
pulley bolt. Than I took a 9/16 socket with and extension to take the nut off. Once I did that,
I was able to get the old pulley out and install the new one. It was hard to do because you have
a small space to get the 5/8 ... Read more wrench in. If I have to replace the other pulley, I am going to remove
the deck from under the mower. I think that would be much easier and will allow the 5/8 wrench
to be used from under the mower frame.

Used extention for 3/8 drive ratchet and a open end wrench.
Loosened the nut with the ratchet while holding the other side of the bolt with wrench.
Replaced the roller on the bolt.
Reinstalled .

Removed battery (mine under seat). for access, remove parts (cables, black plastic pulleys). replace battery, You\'re done! don\'t put cables on in the dark I did got them crossed and the whole mower went dead. just replace the fuse!! my 10amp fuse was under the battery/seat. Its a professional series. yours my be in front under the ho ... Read more od. it cost 95 cent.