Water Pump Engines

This piston ring is an authentic manufacturer approved replacement part. Is is commonly used on Echo gas trimmers/edgers. The purpose of a piston ring is to create an air tight seal inside the cylinder. A worn or broken piston ring will allow combustion gases to escape the seal and enter the crankcase. This would cause low compression and a loss of power. Replacing an o-ring should resolve this is...

This is an OEM Honda part directly sourced from the manufacturer for use in small engines. The governor rod hooks to the governor arm. You may need a wrench and a set of pliers when replacing this part. This item may become broken or bent and will need to be replaced. It is made of metal and is available as an individual replacement part.

This is an original replacement part sourced directly from the manufacturer. The governor rod is commonly found in Honda small engines. This part is made of metal, and is attached to the governor arm. You may require pliers when replacing this product. This item is sold as an individual replacement part.

This piston kit is used to repair or rebuild small 2-stroke engines, helping restore proper compression and engine performance. Typically including the piston, rings, and retaining components, it’s a direct replacement for worn or damaged internal parts and is commonly installed during top-end engine service to correct power loss, hard starting, or low compression.

The governor rod is made of metal. It is an OEM from Honda for use in engines. This part is sold individually. A set of pliers may be required to replace this part. This item might bend or break over time and will need replacing.