Shindaiwa Trimmer Hardware

This is a genuine ECHO/Shindaiwa replacement part It is compatible with over 150 machines listed below. The Fuel Line Grommet is placed into the fuel tank. The Vent tube, Fuel return line and fuel line are inserted through the three holes. A worn Fuel Line Grommet will cause fuel to leak from the tank. When replacing the Grommet it is advisable to replace the fuel lines at the the same time.

This is a genuine OEM replacement part, it is sold individually. This clip is used in various areas of the over 150 outdoor product models shown below. It is most commonly used to clamp hoses or tubes in place.

This is a Genuine OEM replacement part, this item is sold individually. This nut is used on a variety of lawn and garden equipment. Use proper tools tighten or loosen this part. Make sure to tighten the nut, but do not over tighten it.

Genuine Shindaiwa replacement part, this item is sold individually. The Eyelet is installed in the spool housing of the Trimmers shown below. Most of the Trimmers are dual line, so two Eyelets are required. The Eyelet creates a smooth surface for the cutting line to exit the spool.

This manufacturer sourced replacement part designed for use with a variety of handheld lawn and garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. This is a standard hardware which will have multiple applications based on your equipment. This lock nut is made out of metal and it is sold individually.

It is an authentic OEM sourced item that is specially produced for use with Shindaiwa and Echo handheld lawn and garden equipment. This screw is generally used to secure the housing, please make sure to check appropriate diagrams for correct location and use of this hardware. One torx screw is included per order.

This is a Genuine OEM Sourced replacement part designed for use with Lawn and Garden Handheld equipment. The purpose of this clip is to secure the fuel filter to the fuel pick up tube on the unit. This item is made out of Metal and it is Sold Individually.

This is an original manufacturer approved replacement item commonly used on trimmers, brushcutters and edgers. The purpose of this nut is to secure cutter head assembly to the spindle/shaft of a trimmer. It is a metal nut which is sold individually. Please only use properly sized wrench when securing or removing this nut.

This is a genuine OEM sourced replacement part designed for use with Echo blowers/trimmers. This is a standard hardware which has multiple applications based on your unit. Please refer to diagrams for proper application. This screw is made out of metal and it is sold individually. To remove or install this screw you would need a screwdriver.