MTD Trimmer Carburetors

A carburetor basically consists of an open pipe through which the air passes into the inlet manifold of the engine. The pipe is in the form of a Venturi: it narrows in section and then widens again, causing the airflow to increase in speed in the narrowest part. Below the Venturi is a butterfly valve called the throttle valve ' a rotating disc that can be turned end-on to the airflow, so as to h...

A carburetor is an important component which combines fuel and air before the combustible mixture is sent into the cylinder. Over time parts may wear out or get damaged eventually requiring a replacement. Keep in mind this high-quality carburetor is sold as an individual item. Refer to the appropriate diagrams for your model to ensure the correct repair procedure. It is a genuine OEM carburetor wh...

This is an original replacement part sourced directly from the manufacturer. The carburetor is found in Craftsman trimmers. This part is a complete carburetor assembly made primarily of metal, and is used to mix fuel and air together for ignition in the engine. You will require a screwdriver when replacing this item. The carburetor is sold as an individual replacement part.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman trimmers. The carburetor mixes air and gas before the fuel mix goes to the engine. This part comes with the carburetor assembly, as well as the carburetor gasket. Let the engine cool and drain the gas tank before starting this repair. You may need screw drivers and pliers to aid you in this repair.

This is an authentic Walbro repair kit that has been sourced from the original equipment manufacturer. Ethanol in gasoline can build up deposits and over time can clog the fuel passageways inside the carburetor. A clogged carburetor can cause poor engine performance and can prevent fuel from getting into the motor causing it to abruptly shut-off. If this occurs, this kit contains the necessary par...

This is an Genuine OEM replacement part used on Gas-Powered Handheld Trimmers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, ...

This is an authentic OEM produced replacement carburetor assembly. It is specially made for use on handheld gas powered lawn and garden equipment. It mixes air and gas into a combustible mixture that is sent into the engine. This kit includes (1) metal body carburetor, (1) composite gasket, (3) flexible rubber fuel lines and (1) fuel filter. To replace this carburetor assembly you will need a screwdriver.

Carburetor w/Primer Carburetor WYL-229 This carburetor is for line trimmers. Carburetor mixes air and gas before the fuel mix goes to the engine.