Makita Trimmer Caps and Lids

It is not uncommon for the safety cover to become damaged after years of use. It is important to always have this part attached to your trimmer. The cover protects the operator from flying debris. This is a straightforward repair that should only take a few minutes. The cover is held in place by a M4X20 pan head screw, which will need to be removed to access and replace this part. This safety cove...

This is a genuine guard for string trimmers. The guard is made of steel and is silver in color. It is round with an opening in the middle. It fits on top of the receive washer and is part of the motor housing. It is sold individually.

This is an authentic replacement part manufactured for use with backpack blowers from Makita. This part keeps the fuel in the tank. There are no tools needed to replace this part. This cap is made of durable plastic and sold individually.

This is an authentic OEM metal guard for a trimmer. It is 2-and-3/4-Inches in diameter. It is essential for the cutting head to have a guard. Never operate the tool if the guard is damaged or not in place. The guard is located in the motor housing of the nylon cutting head. This part is sold individually.

The plug cap attaches to the ignition coil and is held in place with a plug cap spring. This OEM plug cap is sold separately. This part is black in color and is approximately 1.25-Inches long and 0.75-Inches wide (at the widest part). Twist the old plug cap out of place and use a pair of needle nose pliers to remove the spring inside. This part can wear or crack with time and will need to be replaced.

This item is available as an individual replacement part. The guard attaches to the ball bearing and is made of plastic. During replacement, it may require a wrench to help install this part correctly. It will require replacing if it breaks. This genuine item is supplied by the original equipment manufacturer for use with Makita trimmers.

The wire guard is underneath the motor housing. It is made of metal. It is secured in two grooves in the housing that holds the debris shield to the top part of the motor housing. It is held in place by locking tabs on the bottom of the shield. If this part warps or breaks, it will need to be replaced. Sold separately.

The oil cap attaches to the gasket and is made of plastic. This is an OEM part sourced directly from the manufacturer and used in blowers and trimmers made by Makita. This part is available as an individual replacement. No tools should be necessary during installation. It will need to be replaced if it breaks.

This is a genuine replacement part for Makita table saws and trimmers The rubber cap is designed to fit over the lock lever to provide a soft material for the user's fingers while adjusting the lever. The part is made out of durable rubber. This item is sold individually.