Tiller Control Cables

This forward control cable, compatible with various tiller models, enables forward movement when pulled by the user, engaging the forward gear. Measuring 1440mm (approximately 57 inches) in length, this control cable is equipped with a protective sheath to guard against external damage. It is an OEM part and is sold independently, without any additional securing hardware or parts. If your tiller c...

This is an authentic manufacturer-sourced component which is specially made for use with Craftsman tillers. It provides an identical replacement for a missing or a faulty clutch cable that was installed on a new unit. The cable is an important part that allows a user to control the clutch that engages the unit. Please make sure to refer to the owners manual and the appropriate diagrams of your mod...

This is a genuine manufacturer-sourced replacement component which is specially designed for use with Bolens and Troy-Bilt tillers. The throttle cable is connected to the carburetor and it stops the engine when you shift the lever to the full choke position. It is a high-quality rubber insulated part is sold individually, please note, the housing, the trigger and the hardware are all sold separately.

This is an original replacement part manufactured for use with Troy-Bilt tillers. Cables and break from normal use usually at the ends, and replacing a broken cable is an easy repair to keep the tiller running. This is the forward drive cable and is sold individually.

This is a genuine replacement part manufactured for use with tillers and snow throwers. The cable barrel assembly is used to secure the clutch cable to the clutch control handle. This special cable barrel holder is sold individually.

The reverse cable is made out of metal and plastic and is sold individually. This part is an OEM from Troy-Bilt for use in rototillers. During replacement, it may require a set of pliers to help install this part correctly. It will need to be replaced if it breaks or stretches.

This part is a genuine OEM from Husqvarna. The clutch cable is composed of metal, wiring and plastic. Made for use with several rear tine tillers, this component is fastened to the control bar assembly and the engine's clutch. The clutch cable allows the operator to manage the transfer of power in the tiller engine. You will need a wrench and a pair of pliers for the repair. The clutch cable is sold individually.