Murray Snow Blower Bearings

This authentic replacement part is designed for use with Craftsman snowblowers. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This bearing helps to secure the arbor shaft, allowing it to rotate. Bearings experience constant wear from pressure,...

This is a Genuine Manufacturer Sourced replacement part used on Lawn and Garden Equipment. This part is made out of Metal and it is Sold Individually. Ball Bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to...

This is available as an individual replacement part. The auger bearing connects to the auger plate and is made of plastic. If this part becomes broken it will need to be replaced and may require a screwdriver during the installation. It is an OEM Craftsman part directly sourced from the manufacturer for use in snowblowers.

It is an authentic OEM sourced item which is specially produced for use with Murray, Snapper, and Simplicity snowthrowers. The axle bearing fits between the axle shaft and the flatwasher and helps to reduce friction. During the installation process, a screwdriver and a wrench set might be needed to replace this part. It may become broken and will need to be replaced. This is made of metal and is a...

It is a genuine item that is supplied by the original equipment manufacturer for use with snowthrowers and snowblowers made by Murray, Snapper, and Simplicity. The bushing goes next to the worm chute and is made of plastic. When replacing this part a wrench might be required during the installation process. Over time this part may break and will need to be replaced. Keep in mind this high-quality ...

This authentic replacement part is designed for use with Murray, Simplicity and Snapper snowblowers. Flange bearings are used to provide support for a shaft while reducing friction between rotating parts. The rollers take the load and spin, distributing the weight evenly while the minimal contact area of the roller reduces friction. Bearings experience constant wear from pressure, heat, vibration,...

Brng, fl .752idx1.002

Idler bracket bushing

It is a genuine OEM sourced component which is specially designed for use with snowthrowers. The housing helps to secure and cover the bearing which is sold separately. It is an identical replacement for a missing or a faulty housing-bearing that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardwar...

This is an authentic OEM sourced replacement part that is intended to be used with snowthrowers from Murray, Snapper, and Simplicity. The auger flange attaches to the side of the auger housing. This item is used to support the auger shaft assembly. The flange is sold individually, please note two may be needed.