Weed Eater Leaf Blower / Vacuum Carburetors

This is a genuine manufacturer-sourced replacement gasket repair kit that is specially made for use with Paramount and Poulan lawn and garden equipment. It is utilized to replace carburetor gaskets and diaphragms that were originally installed on a new unit. If you have a problem with your carburetor this will usually take care of it. Keep in mind this high-quality kit is sold individually. Please...

This is a genuine OEM sourced rebuild kit is designed for gas trimmers/blowers. This kit contains all the necessary parts to rebuild your carburetor. It includes: primer bulb, the float, needle, gaskets, seals needed to repair or refurbish a carburetor. Replacing these items you would need a screwdriver and pliers.

Carb. adaptor

This is a genuine OEM replacement part, it is sold individually. It is used on a variety of Gas Powered Equipment. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the e...

This metering diaphragm is an original part for use in edgers, blowers, trimmers, and chainsaws made by Poulan, Paramount, Weed Eater, Husqvarna, and Jonsered. It fits between the metering diaphragm gasket and the metering diaphragm cover. It is made of a thin material and will need to be replaced if it breaks. A screwdriver may be needed when replacing this part and keep in mind that it is sold individually.

This is an authentic OEM sourced component which is specially made for use with gas-powered lawn and garden equipment. The part provides an identical replacement for a missing or a worn diaphragm that was installed on a new unit. It is provides a tight seal for the fuel pump. Please make sure to refer to the appropriate diagrams of your model for the correct repair procedure. Keep in mind this hig...

This is an Original Manufacturer Approved Carburetor Assembly used on Weed Eater Handheld Blower. It has a Metal Body with Plastic Levers. This carburetor is Sold Individually. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoo...

This is a genuine OEM sourced replacement carburetor, it is commonly installed on Craftsman gas powered backpack blowers. The purpose of this part is to mix the air and the gas before the combustible fuel mix goes to the engine. Often if the engine won't start and the tank is full of fresh fuel, or if the engine starts and then quickly dies, the carburetor is likely the problem. This part provides...

The carburetor fits between the air box and the carburetor adaptor and is made of metal and plastic. It is an OEM from Poulan, Weed Eater, and Jonsered and is used in blowers. This part is available individually and may require a screwdriver during installation. It helps with the fuel mix and can be cleaned if it is causing problems with the engine, but will need to be replaced if it becomes broken.

It is a genuine OEM supplied part which is made for Poulan gas powered blowers. This part is used to restrict the flow of air, thereby enriching the fuel-air mixture. Because this part is used quite frequently it has a tendency to wear and may get damaged eventually requiring a replacement. To ensure the exact location and the correct application of this component, refer to the appropriate diagram...