Ryobi Leaf Blower / Vacuum Hoses and Tubes

This is a genuine OEM approved replacement part, it is specially designed for use with Craftsman gas powered lawn and garden equipment. By pressing on the purge bulb, it will force fuel into the fuel line from the fuel tank into the carburetor. Once the carburetor is full of fuel, the excess fuel will be purged back into the tank in the fuel return line. Over time the material may begin to deterio...

The 791-682039 Fuel Filter and Line, filters the fuel in the tank as it is forced into the carburetor up by means of the primer bulb. To install. Remove retainer ring from fuel line. Insert fuel line thru gas cap opening. Thread fuel line thru hole in bottom of the fuel tank. Pull fuel line thru to firmly seat against inside tank wall. Put retainer ring on fuel line,hold line and press ring firml...

This fuel line is an original part from Craftsman for trimmers, blowers, edgers and cultivators. This part is supplying gas, starting with the tank to the carburetor. You will need a screw driver, pliers, a hose pulling wire and cutters to replace this part. This fuel line is made of rubber and sold individually.

It is a genuine OEM replacement part designed for use with Ryobi backpack blowers. This part interlocks with the other blower tubes that are sold separately. Over time this part can crack allowing for air leaks, this will greatly decrease blowing/suction ability of the unit until the part is replaced. This tube is made from high quality plastic and it is sold individually.

The breather hose attaches to the check valve. This item is sold individually and is made out of rubber. This is an OEM part sourced directly from the manufacturer and used in Ryobi blowers, trimmers, and edgers. A set of pliers might be necessary during the installation of this part. It will need to be replaced if it breaks.

This is a genuine OEM sourced part that is specially designed for use with Ryobi lawn and garden equipment. This breather acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won't allow fuel or fuel emissions to leave the tank. Unfortunately, over time the material may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality ...

The Blower tube is an original part manufactured by Ryobi and is used with a cordless 18V blower. This part is made of plastic and attaches to the powerhead without the use of any tools. Please note, this part is sold separately.