Simplicity Lawn Tractor Switches

It is a genuine manufacturer-sourced component which is specially made for use with Murray, Snapper and Simplicity riding lawn mowers and garden tractors. It is the part of the equipment that allows a user to engage and disengage the blades. Unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body switch...

This replacement switch is a genuine OEM part, not an aftermarket equivalent. It is supplied directly from original equipment manufacturer for Murray riding lawn mowers and tractors. This switch is secured under the seat to prevent the engine from running without a driver in a seat. Mechanical switches over time tend to wear out requiring replacement. Please note, this plastic switch is sold individually.

These are authentic replacement parts that are supplied directly from the original equipment manufacturer for use with Murray and Simplicity lawn and garden tractors. This is the ignition switch which is connected to an electric starter motor allowing a user to start the engine with a simple turn of a key. There are multiple reasons a switch could fail, main problems would include either mechanica...

Switch push button no/nc snap-in

This part is available individually and is made of plastic and metal. The limit switch connects to the interlock and helps to turn off the engine if there is a problem. A wrench might be required during the replacement of this part. It will require replacing if it becomes broken. This is a Murray, Snapper, and Simplicity replacement part directly sourced from the manufacturer for use in lawn tractors.

This is a genuine manufacturer-approved part which is designed for Snapper and Simplicity lawn mowers and garden tractors. It is part of the unit handling on/off operation. Unfortunately, over time components may wear out and begin to fail eventually requiring a replacement. Note, this high-quality plastic body switch is sold as an individual component. Refer to the appropriate diagrams for your m...

Switch-push button (normaly open)

The ignition switch attaches to the internal lockwasher and the hex nut. It is an OEM replacement part for use in lawn tractors made by Snapper, Murray, and Simplicity. This part is available individually and is made of metal. A wrench may be required to replace this part if it becomes broken.

It is an authentic manufacturer-sourced component that is specially designed for use with Murray and Simplicity riding lawn mowers and garden tractors. This is the part of the tool that allows a user to turn the unit on and off. Unfortunately, over time mechanical switches will wear out and may begin to fail eventually requiring replacement. This high-quality metal body ignition switch is sold ind...

It is a high-quality replacement for a faulty, a damaged or a missing switch-rocker that was installed on a new unit. It is the switch which allows a user to adjust the cutting height. Unfortunately, over time parts can wear out or get damaged eventually requiring a replacement. Make sure to check the appropriate diagrams for your model to ensure the correct repair procedure. Please note, this hig...

The select reverse switch helps with running the engine while in reverse. This item is priced individually. It is an original part from Murray and Simplicity for use in lawn tractors and rear engine riders. A nutdriver might be helpful during the installation of this part. This item is made out of metal and plastic and will need to be replaced if it breaks.

This is an authentic replacement part for Simplicity riding lawn mowers. The electric clutch power-take-off switch is designed to plug into the wire harness and engage the clutch, propelling the mower forward. The switch is made of high-quality plastic. This item is sold individually.

Switch-op present 3.1

The switch & key is sold as a set that contains all the necessary parts. They are genuine replacement parts sourced from the original manufacturer for use with lawn mowers and lawn tractors made by Murray and Snapper. When replacing these parts a set of pliers might be required during the installation process. They are made of metal and will require replacing if they become broken or lost.

Switch-op presen