Makita Hedge Trimmer Seals and Gaskets

This is a genuine replacement part sourced directly from the manufacturer. The gasket is commonly found in Makita yard tools such as trimmers, brushcutters, and blowers. This part is made of flexible plastic, and is used to seal the connection in the carburetor with the pump body. You will require a screwdriver when replacing this part. This item is sold as an individual replacement part.

This is a replacement part directly sourced from the manufacturer. The O-ring 48 is made of black rubber, and is compatible with siding and coil nailers. This part is designed to absorb pressure between the head valve and valve sheet within the cylinder separator. This part is sold individually. A wrench is needed to make the proper removal and replacement.

Included in part number 5236057000

The rocker cover is a gasket that forms a seal between the rocker cover and the cylinder block. If this gasket fails it could cause oil to leak from the engine. This part is sold individually. Whenever a gasket is removed to perform a repair it is unlikely that it can be reused because it will not provide as good of a seal. If you suspect that the gasket is damaged, it will need to be replaced right away.

Included in part number 5236057000

This black gasket is approximately 1-Inch in diameter and is what creates a seal between the oil cap and oil pipe. Over time this gasket will eventually wear out, crack or break apart. This can cause oil to leak from the cap. Remove the oil cap by unscrewing it from the saw and this should expose the gasket. Make sure it is tight to the housing when placing the new one into position.

This carburetor gasket measures approximately 2.5-Inches long and 2.1-Inches wide. The gasket is constantly exposed to fuel, so over time they will begin to harden and will break down. If the tool is left sitting unused with fuel in it, such as over the winter, this can speed up the process. When gaskets are removed due to other maintenance and repairs, they should be replaced. Gaskets should neve...