Echo Hedge Trimmer Control Cables

It is a high quality OEM sourced replacement throttle cable that is specially made for Echo handheld lawn and garden equipment. Throttle cable is connected to the carburetor allowing user to adjust the choke on the gas powered engine. This durable rubber insulated metal cable is sold individually.

This is a genuine Echo part which is made for use with handheld trimmers. It is a high-quality replacement for a faulty or a missing control cable assembly that was installed on a new unit. The assembly connects to the switch allowing a user to control the equipment. Refer to the appropriate diagrams and the owner's manual for your model to ensure the correct repair procedure. Note, this high-qual...

This part has been OEM sourced to ensure a high level of quality. The throttle cable adjuster is intended to be used with trimmers, edgers, hedge cutters, and pruners from Echo and Shindaiwa. The metal adjuster attaches to the throttle cable and is used to apply tension to the cable. This item is sold as an individual replacement part.

This part is an OEM from Echo. The control cable assembly includes the switch wires, the throttle cable, and is enclosed in a durable sleeve. This item is used to connect the switch and to link the throttle trigger and valve. For the repair, you will need a screwdriver and pliers. This control cable assembly is compatible with many lawn and garden tools, and is sold individually.

This is an authentic replacement part that is sourced from the original manufacturer to be used with hedge clippers. The special throttle cable is used to link the throttle trigger and the valve on the carburetor. Over time cables can wear out and the ends can break. Replacing the cable may require needle nose pliers, a screwdriver, and possibly a hex socket wrench. This throttle cable is availabl...

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Echo edger's. The engine throttle control controls the engines speed. This part is made of metal and is sold individually. For installation you will need a wrench and screw driver. Make sure that the engine has cooled before you start the repair.