Craftsman Engine Springs and Shock Absorbers

This spring is an OEM part which is designed for use with Husqvarna, Poulan and Jonsered riding lawn mowers and garden tractors. The spring applies tension on the rod tension relief. Over time it may wear out or get damaged eventually requiring a replacement. It is made of high-quality metal and is sold as an individual component. Make sure to check the diagrams of your model for the exact locatio...

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with riding lawnmowers. The metal spring is used to provide torsion on the grass deflector chute to allow the chute to be pliable. This spring is available as an individual replacement part, please see illustrated diagram for related parts.

This is an authentic manufacturer-sourced replacement part which is specially designed for use with Murray and Snapper lawn and garden equipment. It helps to distribute the pressure evenly and provide a tight seal between connected parts, please make sure to check the appropriate diagrams of your model for the correct location of this hardware. Keep in mind this high-quality item is made of durabl...

This manufacturer approved recoil starter pulley is designed for lawn and garden equipment engines. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. This assembly includes: Plastic Pulley and a Metal Recoil Spring.

This is an original part from Husqvarna for use with Lawn Tractors. The compression spring attaches to the height indicator bracket and provides a cushion as the bracket moves up and down to indicate the cutting height. The most common reason for replacing the compression spring is if the blades won't turn. This part is sold individually. The tool needed to replace the compression spring are pliers.

This is a genuine OEM sourced part which is specially designed for use with Ryobi and MTD lawn and garden equipment. It is an identical replacement for a missing or faulty extension spring that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is mad...

The governor spring is made out of metal and helps to control the speed of the engine. This authentic item is supplied directly from the original equipment manufacturer for use with Briggs & Stratton generators and Toro snowthrowers, tillers, and blower-vacuums. If it becomes lost or broken it will need to be replaced. A nutdriver may be necessary to help replace this part which is sold individually.

This is an authentic manufacturer made replacement part which is specially designed for use with Craftsman lawn tractors. The latch spring puts tension on the seat latch to hold it in the correct position. This part is made of metal and is sold individually. For installation, you will need a screwdriver to remove any panels or covers, and a socket wrench set to aid you.

The spring attaches to the pulley bracket. This is a genuine Ridgid replacement part for use in drain cleaners. This item is sold individually. It will need to be replaced and may require a wrench and a set of pliers during the installation. It is made of metal and will require replacing if it becomes bent broken.

This part is an OEM from MTD for use with Snowblowers. The most common reason for replacing the throttle spring is when it is damaged during another repair. This part is sold individually. Here is a list of tools that are needed to replace the throttle linkage spring needle nose pliers, 3/8 inch socket, 1/2 inch socket, 3/4 inch socket, 10 mm socket, Phillips-head screwdriver and a 5/16 inch wrench.