Briggs and Stratton Engine Valves

This is a geniune OEM part. The Briggs & Stratton, 10-16 amp voltage regulator is composed of metal, wiring and plastic parts. The regulator is compatible with many lawn and garden machines. This part is connected to the engine's terminals, and has been designed to manage the voltage in the device's electrical system. A screwdriver and a socket set are needed in making the removal and repair. It i...

This is an authentic OEM sourced part that is intended to be used with small engines from Briggs & Stratton and Toro. The shut-off valve attaches to the bottom of the fuel tank and is used to link the fuel line and to control the flow of fuel that goes to the engine. This item is available as an individual replacement part.

This is a genuine OEM part that is intended to be used with lawnmower engines from Briggs & Stratton, Toro, and Murray. The valve attaches to the incoming fuel line and is used to regulate the flow of fuel that enters the engine. This item is available as an individual replacement part.

The float valve is used to allow fuel into the float chamber when the chamber has been drained and to stop fuel from entering the chamber when it is full. It provides an identical replacement for a missing or a faulty component that was installed on a new unit. This authentic part is supplied by the original equipment manufacturer for use with Kawasaki engines commonly installed on lawn and garden...

This authentic manufacturer-sourced 5-9 amp regulator is made for Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a missing or a damaged component that was installed on a new unit. Refer to the owner's manual and the appropriate diagrams for your model to ensure the correct repair procedure. It is sold as an indi...

This is an original Briggs & Stratton and Toro part for use in engines, generators, and lawn mowers. The exhaust valve goes next to the valve spring. This item is sold individually and is made of metal. A set of pliers may be needed during the replacement of this part. It will need to be replaced if it breaks.