Dethatcher Carburetors

This is the replacement carburetor kit for your small engine, used for outdoor power equipment. The carburetor rebuild kit includes the float, needle, gaskets, and seals that you need to refurbish your carburetor. The carburetor is essential to proper engine performance so if it is dirty or damaged, it is recommended that you repair it using one of these carb kits. If basic adjustments to your car...

This genuine OEM sourced replacement part is designed for use with lawn and garden equipment engines. The purpose of a carburetor is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine sta...

This is a genuine manufacturer-sourced part that is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is generally utilized to provide an air-tight seal for the carburetor, please make sure to check the diagrams of your model for the correct location and application of this hardware. Unfortunately, over time gasket material may deterior...

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or a faulty link-throttle that was installed on a new unit, please make sure to check the diagrams of your model for the correct location and application of this hardware. Kee...

This item has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton. The float needle valve is used with the carburetor assembly. This item attaches to the float and allows fuel into the carburetor when the fuel is drained and stops the fuel when the bowl is full. This item is available as an individual replacement part.

The choke shaft kit is sold as a set that contains the choke valve, the spring/seal, and the choke shaft. A set of pliers might be needed during the installation process. They are made of plastic and metal and will need to be replaced if they become broken. These are OEM Briggs & Stratton parts directly sourced from the manufacturer for use in engines.

This is an original replacement part sourced directly from the manufacturer. The throttle link is commonly found in Briggs & Stratton engines. This part is made of metal, and is used to connect the linkage lever. You may require pliers when replacing this item. The throttle link is sold as an individual replacement part.