Chipper Shredder Springs and Shock Absorbers

This genuine OEM sourced replacement part is designed for use with blowers/trimmers. This is the spring for the spark plug boot. This spring is made out of metal and it is sold individually.

This item has been sourced from the original manufacturer and is intended to be used with trimmers, edgers, and blowers from Echo. The metal spring is part of the recoil starter assembly and is used to rewind the starter rope after it has been pulled to start the motor. This item is sold as an individual replacement part.

This manufacturer approved recoil starter pulley is designed for lawn and garden equipment engines. The recoil starter engages the drive cup on the flywheel to start the engine when pulled. This assembly includes: Plastic Pulley and a Metal Recoil Spring.

This part is an authentic manufacturer-sourced replacement part which is specially designed for trimmers, brushcutters and blowers. This part is sold individually and made of metal. The return spring helps return the starter pawl back to the regular position after you are done starting the engine with the recoil starter.

This is a genuine OEM sourced part which is specially designed for use with Ryobi and MTD lawn and garden equipment. It is an identical replacement for a missing or faulty extension spring that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality item is mad...

This is a manufacturer approved replacement part designed for use with a variety of lawn and garden engines. The air vane spring maintains the proper tension on the air vane choking system. If it is broken, it can cause the engine to not start. To replace it you will need pliers.

This is an authentic Ridgid item that is supplied directly from the original manufacturer. It is designed for use with power drives. A washer is a special part which helps to provide a tight fit for the armature bearing. This part provides an identical replacement for a damaged or a missing hardware that was installed on a new unit. Make sure to check the appropriate diagrams for your specific mod...

This part is an OEM from MTD for use with Snowblowers. The most common reason for replacing the throttle spring is when it is damaged during another repair. This part is sold individually. Here is a list of tools that are needed to replace the throttle linkage spring needle nose pliers, 3/8 inch socket, 1/2 inch socket, 3/4 inch socket, 10 mm socket, Phillips-head screwdriver and a 5/16 inch wrench.