Jonsered Chainsaw Springs and Shock Absorbers

This is an authentic Poulan replacement part manufactured for use with gas powered chainsaws. The ignition switch spring is used to put tension on the throttle control lever. This ignition switch spring is sold as an individual replacement part, please see model diagram for associative parts.

This is an authentic Husqvarna replacement part that has been sourced from the original manufacturer to be used with chainsaws. The metal spring is part of the rear handle and is used to provide tension on the trigger to keep the trigger pressed outward. This item is available as an individual replacement part.

This item has been sourced from the original manufacturer to be used with chainsaws and brushcutters from Husqvarna and Jonsered. The metal recoil spring is part of the starter assembly and is used to pull the starter rope back after it is pulled to start the motor. This spring is priced as a single item.

This replacement part is sourced from the original equipment manufacturer. It is specially designed for use with Poulan, Husqvarna and Jonsered chainsaws. The spring is an important component of the starter mechanism. It applies tension on the pulley allowing it to retract. Unfortunately, over time it may wear out, get damaged or lost eventually requiring a replacement. Please make sure to refer t...

This is a genuine OEM sourced component which is designed for use with Husqvarna chainsaws. This is one of the special springs for the clutch. It is an identical replacement for a missing or a faulty item that was installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this spring. Keep in mind this high-quality part ...

This spring cassette assembly is used in recoil starter systems to retract the pull cord after starting and provide the tension needed to engage the engine. Housed in a self-contained cassette for easier installation, it’s a direct replacement when the starter rope feels loose, fails to rewind, or no longer engages properly, helping restore smooth and reliable starting.

It is an authentic OEM sourced item which is specifically produced for use with Husqvarna and Jonsered chainsaws. The spring fits onto the knee joint and is made of metal. During installation, a wrench set, a screwdriver, and a set of pliers may all be needed to help replace this part. It will need to be replaced if it becomes broken or stretched. Keep in mind that this part is sold individually.

This authentic item is supplied directly from the original equipment manufacturer for use with chainsaws made by Husqvarna and Jonsered. The spring attaches to the throttle control. A set of pliers may be necessary during the installation of this part. It is made of metal and will require replacing if it breaks or stretches. This is available as an individual replacement part.

This part is an OEM from Husqvarna. The metal spring is made for use with several chainsaws. This item helps to secure the pawl to the flywheel, and is sold individually. A hex key and a pair of pliers are often necessary for the installation.

This part is an OEM from Husqvarna. The metal clutch spring is compatible with many lawn and garden engines. The spring is fitted in the clutch, cushioning the clutch's movement. Keep in mind, two springs are needed. An Allen wrench and a pair of pliers are often necessary for the installation. Please refer to the specific manual and diagrams for additional instructions. The clutch spring is sold individually.