Shindaiwa Brush Cutter Seals and Gaskets

This is a genuine manufacturer sourced replacement part designed for use with handheld lawn and garden equipment. It provides a seal for the gas cap. Over time seal will become brittle and compressed, then will have to be replaced. This part is made out of composite material and it is sold individually. No tools needed to replace this gasket, simply remove the old one and place a new gasket inside the fuel cap.

This is a genuine OEM approved replacement part for use with lawn and garden equipment. It is designed to provide a seal for the fuel cap to keep the fuel/oil in the tank. It is made out of rubber material and it is sold individually.

This oil seal is an OEM part that is used in trimmers, blowers, and edgers made by Shindaiwa and Echo. This item is a part of the small block assembly and is used to prevent oil leaks from between the crankshaft and the crankcase. The oil seal is priced individually, please note that two seals might be required.

This item is supplied directly from the original equipment manufacturer for use with Shindaiwa and Echo handheld lawn and garden equipment. It is utilized to provide a tight seal between the cylinder and the insulator, over time it may wear out and begin to crack eventually requiring a replacement. Keep in mind this high-quality component is made of durable composite material and is sold individually.

It is a genuine replacement part that is supplied directly from original equipment manufacturer for use with Shindaiwa gas-powered lawn and garden equipment. This is the oil seal for the crankcase, please refer to appropriate diagrams of your model for correct location and use of this item. If you have noticed any leakage from the crankcase past the seals or along the crankshaft, the oil seals are...

This is an authentic replacement part manufactured for use with Shindaiwa outdoor power equipment. The special gasket is used to seal the connection between the carburetor and the insulator. It is recommended to replace gaskets when servicing the carburetor to ensure proper seals when the parts are reinstalled. This gasket is available as an individual replacement part.

This is an original Shindaiwa replacement part manufactured for use with outdoor power equipment. The o-ring is used to form a seal between part assemblies, usually where there is a shaft through the assembly. This is a versatile replacement part used with several different models. This o-ring is sold individually, please see model diagram for associative parts.

This is an original Shindaiwa replacement part manufactured for use with outdoor power equipment. This special oil seal is used to seal the opening in the crankcase where the drive shaft exits. This seal allows the drive shaft to rotate while preventing oil from leaking out of the crankcase. The oil seal serves a vital engine function and is sold individually.