Shindaiwa Brush Cutter Hardware

This is a genuine OEM replacement part, it is sold individually. This clip is used in various areas of the over 150 outdoor product models shown below. It is most commonly used to clamp hoses or tubes in place.

This is a Genuine OEM replacement part, this item is sold individually. This nut is used on a variety of lawn and garden equipment. Use proper tools tighten or loosen this part. Make sure to tighten the nut, but do not over tighten it.

Genuine Shindaiwa replacement part, this item is sold individually. The Eyelet is installed in the spool housing of the Trimmers shown below. Most of the Trimmers are dual line, so two Eyelets are required. The Eyelet creates a smooth surface for the cutting line to exit the spool.

This manufacturer sourced replacement part designed for use with a variety of handheld lawn and garden equipment. A lock nut is a type of nut that resists loosening when properly threaded onto a bolt. This is a standard hardware which will have multiple applications based on your equipment. This lock nut is made out of metal and it is sold individually.

This is a Genuine OEM Sourced replacement part designed for use with Lawn and Garden Handheld equipment. The purpose of this clip is to secure the fuel filter to the fuel pick up tube on the unit. This item is made out of Metal and it is Sold Individually.

This is an original manufacturer approved replacement item commonly used on trimmers, brushcutters and edgers. The purpose of this nut is to secure cutter head assembly to the spindle/shaft of a trimmer. It is a metal nut which is sold individually. Please only use properly sized wrench when securing or removing this nut.

This is a genuine OEM sourced replacement part designed for use with Echo blowers/trimmers. This is a standard hardware which has multiple applications based on your unit. Please refer to diagrams for proper application. This screw is made out of metal and it is sold individually. To remove or install this screw you would need a screwdriver.

This washer is available as an individual replacement part. It is used in various lawn and garden tools made by Echo and Shindaiwa. The washer attaches to the cylinder cover with a screw. It is made out of metal and is very small, so it will need to be replaced if it becomes lost or broken. An allen wrench will be needed when replacing this washer which is an authentic OEM part.

It is a genuine OEM sourced replacement part that is specially made for use with Echo handheld lawn and garden equipment. This screw has multiple applications depending on the model of your unit, please refer to appropriate diagrams for correct location and use of this hardware. It is made from high-quality metal and it is sold individually.