Brush Cutter Ignitions

This is an authentic OEM part for use with Husqvarna Trimmers. The ignition module controls ignition timing and sends voltage to the spark plug. The most common reason for replacing the ignition module is when the engine won't start or is hard to start. This part is sold individually. The tools that you will need to replace the ignition module is a screwdriver, nut driver and a socket wrench.

It is an authentic OEM supplied replacement part that is specially produced for Husqvarna handheld lawn and garden equipment. The ignition module also known as an armature-magneto provides electric current for the ignition system sending pulses of high voltage to the spark plug. The primary symptoms of a faulty module usually would be difficulty starting your equipment or inability to start it at ...

This is an authentic replacement part manufactured for use with Husqvarna gas powered trimmers and brushcutters. The ignition module is used to create an electric charge when the magnet on the flywheel passes, and the charge is sent to the spark plug to ignite the fuel and air inside the combustion chamber. Often times a faulty ignition module will prevent the engine from starting, and this igniti...

This is a genuine OEM sourced part used on many brushcutter devices. The ignition module mb50 is designed to send electrical current to the spark plug. Constructed of high-quality metal, wiring and rubber, this item is sold individually. An Allen wrench and a pair of pliers are necessary for making the replacement. It is encouraged to refer to the manual for safety and repair instructions.

This is an original part from Shindaiwa for use with Line Trimmers, Hedge Trimmers, and Edgers. The ignition coil supplies spark voltage to the spark plug on the engine. The most common reason for replacing the coil is if the engine won't start or run. This part is sold individually. The tool that you will need to replace the ignition coil is T-25 Torx head screwdriver.

This is a genuine part that is supplied by the original manufacturer for use with Husqvarna polesaws. The ignition coil generates the voltage for the spark plug. This part comes with the ignition wire, module, and spark plug boot. For this installation, you will need a screwdriver to remove the any engine shrouds or covers, as well as needle nose pliers to disconnect the ignition coil from the engine.

Ignition module mbu-18