All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
15 - 30 mins
(3 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Impact driver was not that old but the motor smoked while using it. Took the gun apart and desoldered the wires to the motor and soldered on the new motor. While putting the gear assembly back togeth
1. Remove the screws holding the gun together. Battery should be out already!
2. Remove little metal clip in battery compartment.
3. Lift up one half leaving the other flat on the bench.
4. Remove the 4 metal pins holding the gear assembly and anvil to the motor. They just
push out easily with a pick or very
... Read more small screw driver.
5. Be mindful when you pull the sections apart (3) because the reduction gear assembly will
be messy and coated in grease.
6. Un-solder the old motor wires and solder in New wires. Be careful with the wire routing
because it is a tight fit! Take pictures ahead of time to be safe.
7. Put gear reduction assembly back together and grease liberally. Match up with the gear
on the motor until it lines up with the contours of the motor.
8. Put on the anvil and install the pins back holding the unit together. One set of pins is
longer than the other.
9. Carefully put everything into the housing and make sure the fit is closed before you put
the screws back in!
10. Install screws and metal clip inside the battery compartment.
11. Install the battery and have at it!
Read less
Did you find this story helpful?
Thank you for voting!
Had to replace electric motor inside of impact drill
Removed old motor from Milwaukee cordless impact which was full of metal fragments from workplace,ordered new motor, installed new motor, soldered wires on new motor, completed assembly, very pleased
disassembled drill driver. removed motor and circuit board. Unsoldered wires and soldered to new motor. reassembled drill and everything worked fine. I\'ve used it several times since repair. I\'m currently going to order a motor for a 18v drill to repair. I\'ll lt you know how that goes. P.S. I\'m an Auto mechanically so I\'ve got skill
... Read mores that some might not have. If you are somewhat mechanically inclined you can make this repair. Just pay attention upon disassembly as to where the parts go.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP11877275
Manufacturer Part Number: 23-30-0430
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
