The handle and finger guard have to be removed. Once removed, all the screws holding the two halves of the component enclosure have to be removed. This exposes the blade and gear assembly part. Care must taken as the blade and gear assembly have to be lifted out of the casing. Be extremely careful handling the new blade assembly. It\'s s
... Read moreharp. When changing the blade, the motor, control board and wiring are all attached. The blade / gear is attached to the motor, etc. Two bolts, two stepped washers, and a retainer bar hold the blade assembly to the motor. Once replaced, everything has to get reversed. Care must be taken as the trigger can easily get dislodged. Pay attention to everything as you separate the the two halves of working mechanics inside as you disassemble. Be careful pulling on wires and making sure they are properly seated in their holding slots so that they don\'t get pinched when reassembling. Don\'t forget to clean out any organic material inside the gear space. Apply a small amount of gear grease to the new blade / gear before closing up the two halves or clamp shell housing. Replace the handle and finger guard.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP18989022
Manufacturer Part Number: 90597361-02
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
