Heater Hoses and Tubes

This is an authentic component which is sourced directly from the original equipment manufacturer for use with kerosene forced air heaters. The line is utilized to carry the air between the combustion chamber and the fan assembly. Unfortunately, over time the material will wear out and may begin to crack eventually requiring a replacement. Please make sure to refer to the appropriate diagrams of y...

This is a genuine OEM replacement part designed for use with Pro Temp, Heat Stream and Master kerosene forced air heaters. The line is utilized to deliver the fuel from the tank into the carburetor. When you press the primer bulb, it will purge all the air out of the carburetor and fill its chambers with fuel. The excess fuel is then forced back into the tank through the return line. Unfortunately...

It is an authentic manufacturer-supplied part which is specially designed for Mr. Heater and Heatstar kerosene forced air heaters. The tube allows the air to travel from the pump. Over time the material may wear out and begin to crack eventually requiring a replacement. Note, this high-quality part is made of durable rubber and is sold as an individual component. To ensure the proper replacement p...

This is a genuine manufacturer-sourced component that is specially designed for use with kerosene air heaters. The purpose of this line is to supply fuel from the tank to carburetor. By pressing the primer bulb it will fill the carburetor with fuel, once it is full the excess fuel will be forced back into the tank through the fuel return line. It is a high-quality line which is made of durable rub...

This is an OEM part sourced directly from the manufacturer. The nozzle kit is found in heaters from Pro Temp, Heat Stream, and Master. This part is made of metal, and is used to inject fuel into the combustion chamber for ignition. You may require a wrench when replacing this part. This item is sold individually.

This is an authentic replacement part sourced directly from the manufacturer. The air line is commonly found in forced air heaters from Pro Temp, Heat Stream, and Master. This part is made of flexible rubber, and is attached to the burner head assembly to carry air. You may require a screwdriver or wrench when replacing this item. The air line is available as an individual replacement part.

This is an authentic OEM part sourced from the original manufacturer. This nozzle fits into the burner head. Kit includes 2 Washers, Nozzle Spring and Black Nozzle Seal (not pictured). Note that any O-rings, nuts, etc. are sold separately. It is recommended to clean or replace nozzles annually and when error code "E1" is displayed. This part is sold individually.