This is an authentic keyless chuck sourced from original manufacturer. It is specially designed for Dewalt hammer drills. The purpose of a chuck is to secure drill bits. This is a keyless chuck allowing easy bit change without any tools. This chuck is sold individually. Please note the screw used to secure it is sold separately. To replace this chuck you would need a screwdriver. • Make sure the unit is unplugged • Remove chuck screw • Remove old chuck • Install new chuck • Reassemble and test the drill
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Genuine replacement
Genuine replacement, excellent service!
Guest - August 18, 2021
Verified Purchase
★★★★★
★★★★★
Dewalt replacement parts
I recently had a couple of parts break on my Dewalt cordless drill and router. I looked for parts all over San Diego and on line, told they were discontinued items. Found eReplacementParts on line. Had exactly what I needed, they were ordered, shipped and received. I Replaced the parts and I'm back on business. I'm a customer for life. THANK YOU NG !!!
Nick - November 5, 2021
Verified Purchase
★★★★★
★★★★★
Drill chuck replacement
The part was exactly the correct part which was easy to order from the breakdown provided on your website. Replacement was quick and easy.
Guest - December 7, 2021
Verified Purchase
★★★★★
★★★★★
Perfect Match
Looks exactly like the original when it was brand new. Guys, keep this in your address book, they have lots of replacement parts
Guest - November 10, 2023
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
The screw holding the chuck has reverse threads. Remove the chuck screw. Place the transmission in low gear and in the drill mode. Insert the short end of the largest allen wrench that will fit into the chuck, then tighten the chuck up. Place the drill on its side . Then strike the allen wrench with a hammer. It will loosen the chuck from
... Read more the spindle. Remove the old chuck and thread on the new chuck hand tight, and screw in the chuck screw.
1 remove chuck screw
2 place Allen wrench in chuck
3 set drill to number one on tork
4 spin chuck on reverse, at the same time hold allen wrench and spinn off.
5 put new chuck on and then set screw
Screwed in new chuck, tightened with allen wrench. Very easy repair. The most difficult part of the repair was removing the old seized chuck.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
