Part Location Diagram of 67829 Weber Cookbox
See part 10 in the diagram
( Grid squares measure 1x1 inch )

Cookbox 67829

Manufactured by:
Weber
ERP Number:
ERP10511332
Part Number:
67829
Original Equipment Manufacturer ?
  Works with your model  83740101!
$348.86
Special Order

A Bit Difficult 

More than 2 hours 

(1 rated repair) ?
  Works with your model   83740101!

Product Description

?

This is an authentic Weber replacement part, sourced from the original manufacturer for use with outdoor gas grills. The metal cookbox is the grill's main housing that supports the drip tray, burners, and cooking grates. This cookbox is available as an individual replacement part, please see model diagram for associative parts.

Troubleshooting

This part works with the following brands:
  • Weber
This part works with the following products:
  • Grill

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

More than 2 hours 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Firebox on grill had burned through on 10-year-old grill. Other parts needed replacement

John from Sumner, Washington

2 of 2 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
Parts Used:
65937, 88070, 67829
1. Remove the grill lid - this was the most difficult step as both clevis pins had fused with the hinge and they sheared off when I tried to remove them. Tried to drill them out and use a bolt extractor, but they never did budge. Uses drill to clean the hole on the lid hinge.
2. Followed clear, step-by-step directions to remove pane ls, burners and brackets using screwdriver and socket set.
3. Bolts connecting old firebox to frame were corroded from moisture and heat. Used Dremel to cut through those and pop off the bracket.
4. Further steps were straightforward per included directions.
5. Also replaced burners and starter.
6. Grill works like new again!
Did you find this story helpful?
Thank you for voting!
  • 1