This replacement divider is an authentic stainless steel item that is sold individually. It is secured between burner tubes to help distribute the heat evenly, another benefit of this part is to direct food drippings helping with the clean up. Over time in combination of heat and moisture the metal may begin to rust and the divider will need to be replaced. It is advised to clean your grill with warm water and soap after each use to prevent warping or rusting.
Removal of parts: grill grates, Flavr Bars, and dividers.
Turn off gas at tank and remove hose from tank
1. After pulling off the 3 gas burner Control knobs and the starter button, Used philips screw driver to remove The front cover. Two screws on each side of cover.
2. To increase accessibility to burners disconnect st
... Read morearter mechanism on inside of front cover just removed.
3. On inside of grill tub the burners are connected To the back via the crimped thin edge of the Burners. Use Large wide flat screw driver By inserting it between the burnerGÇÖs thin edge and the back of grill tub. Use the screw driver to force the burner out from the hex head bolt holding it in place. May need to use a hammer to break the Rusted burner loose from the bolt. Hit lightly on each side of burner hear the bolt until movement is detected.
4. Pull out burner support bar.
5. While all parts are removed from grill tub, clean the grill tub.
Installing new parts:
6. Install new (or old) burner support bar Making sure the electrodes (creates sparks for igniting the gas) are protruding up through the support bar.
7. Install burners by first inserting the gas intake end through Hole in front side Of grill tub. Lay the Back end of burner Down to the hex head bolt so that The burnerGÇÖs thin edge can be inserted Under the Head of the bolt. Using a hammer, Very lightly tap on the gas intake End to help secure the thin edge of burner to the bolt.
8. Once all burners are installed, install the new dividers.
9. Install the Flavr Bars
10. Reinstall the grill grates.
11. Reinstall the starter button on the inside of cover.
12. Carefully reinstall the front cover making sure the gas supply nipples insert completely into each of the Burner intakes.
13. Push front cover in place without screwing it in.
14. Reconnect the gas hose to tank and turn on the gas supply.
15. Do a test start of the grill. May need to make adjustments To the air intake on each burnerGÇÖs intake. Will need to pull open the front panel To have access to the air intake. (No instructions here on proper adjustment).
16. Once adjustments made and another test start works satisfactorily. Screw the front cover on and replace the control knobs.
DONE.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP12009714
Manufacturer Part Number: 18529
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_1.gif "Part Location Diagram of 18529 Broil King Divider")
_WW_1.gif "Part Location Diagram of 18529 Broil King Divider")
