Panel Mounting Clips 5304406520

Cleaned the broken ones out and popped in new ones

The most difficult part was removing the old clips from the broken inner lid without damaging the gasket I then let the old lid rest on top of the freezer to hold the cold in the freezer. I didnÆt turn off my freezer. When I removed the light and switch, I had to take care by taping the wire to the outer lid to prevent electrical shock( ... Read more the safer way to do this is to unplug the freezer). I then used a hair dryer to melt the frost from the insulation. Once the ice was removed, I replaced the insulation in the upper lid using double stick tape and large rubber bands to keep it in place while drying (again, I used the hair dryer to speed up the process). In the meantime, I placed the gasket around the new inner lid (the gasket only fits the attaching holes in one direction). I then discarded the broken inner lid. I began installing the new lid and old gasket. The first step was to replace the light and switch in the new lid. I started by replacing the 4 screws first. Do not tighten them until all clips are in place. This will allow you to adjust the lid so all holes align. Then I placed all clips in the remaining holes, tightened the 4 screws, and closed the lid. Job complete.
Note: Make sure your purchase includes new clips. You canÆt remove the old clips without damaging them.