This is an original Husqvarna replacement part. The input shaft is designed by the manufacturer for use in tillers. This part is made of metal, and is placed in the gearcase and transmission assembly to interact with the input pinion. You will require a wrench when replacing this item. It is advisable when removing multiple parts to keep careful track of their order so they can be reassembled correctly. This product is sold individually.
Troubleshooting
This part works with the following brands:
Husqvarna
Jonsered
Poulan
Weed Eater
Craftsman
This part works with the following products:
Tiller
Cultivator
Part# 532145101 replaces these:
532145101,
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Replaced needle bearings, drive chain and the input shaft. it was pretty much a straight forward disassembly of the entire rototiller. With the exception of the removal of the left hand side tines and drive wheel. It required using the two arm puller for removal of these items. the only issue I had with reassembly was the rear tine axle
... Read moreseals. they had a pretty tight tolerance, and I had to heat them up to expand them to fit on the hubs. As far as special instructions, I would recommend not removing the three shaft nuts on the left hand side of the transmission during disassembly and splitting of the transmission body. It\'s not needed, and the re-tightening of these nuts can be a little tricky as far as over tightening them. You should turn the Tine axle during re-tightening to make sure all of the gear works is turning smoothly before you move to reassembly of the rest of the tiller. Nothing worse than taking it back apart to loosen something.
Read less
Did you find this story helpful?
Thank you for voting!
Tines would not engage
Larry from Licking, Missouri
2 of 3 peoplefound this instruction helpful.
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
1. Took entire tiller apart .
2. Removed motor.
3. Tore down transmission .
4. Checked condition of all parts .
5. Cleaned all good parts .
6. Ordered parts needed.
7. Received parts .
8. Put transmission back together .
9. Put tiller back together.
10. TAKE LOTS OF PICTURES AS YOU T
... Read moreAKE THE TILLER APART . THIS WILL BE VERY HELPFUL .
11. Used over a gallon of marine grease .
12 . Make sure the transmission moves in every gear before reassembling tiller .
13. Replace ALL bearings .
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9011050
Manufacturer Part Number: 532145101
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
_WW_7.gif "Part Location Diagram of 532145101 Husqvarna Shaft.Input.")
_WW_7.gif "Part Location Diagram of 532145101 Husqvarna Shaft.Input.")
