This item has been sourced from the original manufacturer to be used with table saws from Makita. The knob is used to link the handwheel to the blade adjustment assembly and is used to change the position of the blade. This item is priced as an individual replacement part.
1. Sprayed penetrating oil on the roll pin that secured the handle.
2. Using a steel pin punch and hammer, gently tap out the roll pin and slide the old handle off.
3. Unscrew 2 Phillips head screws holding the old rack plate.
4. Screw on the new rack plate.
5. Slide the new handle on and using steel pin punch and
... Read morehammer, gently reinsert roll pin.
The process was incredibly simple
Read less
Did you find this story helpful?
Thank you for voting!
plastic gears sheared off at 90 and 45 degrees and then on the crank
had to drill the spring steel pin out of the crank. that was a pain in the a.. but once that was out, the rest went fairly eazy. if you think you can just push that pin out.... it won\'t come out. after that pin is out ,you slide the height adjustment handle off .slide the blade over to 45, slide the crank off. two screws to remove the g
... Read moreear plate.and then reassemble in reverse order. ilke i said earlier, once that pin is gone ,eazy pezy. good luck !
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
