Part Location Diagram of 92-225-8 Walbro Gasket Pump
See part 26 in the diagram
( Grid squares measure 1x1 inch )

Gasket Pump 92-225-8

Manufactured by:
Walbro
ERP Number:
ERP10024364
Part Number:
92-225-8
Original Equipment Manufacturer ?
Special Order
Minimum Quantity of 2 required

A Bit Difficult 

1- 2 hours 

(2 rated repairs) ?

Does this part fit my model?

Need help finding your model number?

Product Description

?

This is an authentic Walbro replacement part manufactured for use with small engine carburetors. Over time soft passages in the carburetor can wear out which can affect the engine's performance. It is recommended to replace gaskets when servicing the carburetor to ensure proper seals and passages when the carburetor is reassembled. The fuel pump gasket is available as an individual replacement part, please see model diagram for associative parts.

Troubleshooting

This part works with the following brands:
  • Walbro
This part works with the following products:
  • Engine
Part# 92-225-8 replaces these:
92-225, 92-225-8,

Customer Part Reviews

?
5.0
Average Rating (out of 5):
★★★★★
★★★★★
(1 Review)
Click to filter by ratings:
  • 5 stars
    1
  • 4 stars
    0
  • 3 stars
    0
  • 2 stars
    0
  • 1 star
    0
  • 1
Sort by:  
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

1- 2 hours 

(2 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Saw would not run due to clogged carb

Mahlon from Southold, New York

5 of 5 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Removed the carb
Disassembled Carb
Blew out passages
Installed new parts and gaskets
Blew out lines from primmer and fuel tank
Reinstalled carb
Works like a charm
Did you find this story helpful?
Thank you for voting!

It would not stay running.

Tommy from Loreauville , Louisiana

4 of 4 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Wrench set
Parts Used:
95-526-9-8, 92-251-8, 92-225-8
Removed carburetor and clean and replaced all parts listed.
Did you find this story helpful?
Thank you for voting!
  • 1