Filtr:fuel 75 Micron (gravty F 2505021-S

1) Removed cowl from mower for access to carburetor. Removed air cleaner.
2) Removed and disassembled carburetor paying attention to how throttle and governor linkages are hooked up. (A picture taken with phone is a handy reference for re-assembly.)
3) Cleaned carburetor as much as possible with spray carb cleaner, brush and ... Read more shop air.
4) Placed metal parts of carb in dip basket, soaked in gallon of carb cleaner overnight to remove residue.
5) Reassembled carburetor using parts from repair kit and bowl replacement kit. The mower originally had a solenoid to close off fuel flow when shut off, this was replaced with a bowl mounting plug from the bowl replacement kit. (Replacement solenoid is $70, a $3 on/off valve in the fuel line performs the same function.
6) Cleaned all traces of old gasket from engine block, installed carb using new gasket.
7) Cleaned gas tank, replaced old fuel line and fuel filter. Installed in-line fuel shut off valve.
8) Installed air cleaner assembly, replaced old air filter & pre-filter.
9) Checked oil level, added fuel, and started mower.
10) Ran mower for a few minutes to bring oil up to operating temp. Shut off, drained oil, replaced oil filter and filled with fresh oil.
11) Started mower, let run for a few minutes to check for leaks, shut off fuel flow to carb and let run till motor dies from lack of fuel.

Simple, drill down method. Start at the top, remove the old, eaten, or otherwise worn out items until satisfied with whats left. Reinstall in reverse order, test run, mow yard.

1. Remove air filter cover and air filter.
2. Be sure fuel tank is empty. (I turn it sideways below the steering column so the outlet is below the fuel filter.)
3. Remove fuel filter from fuel line and disconnect fuel line from carburetor.
4. Remove ground wire and disconnect wiring from bottom of carburetor float bowl. ... Read more
5. Use socket or nut driver to remove 2 nuts holding carburetor on engine.
6. Gently slide carb off bolts and carefully remove choke and throttle cables (requires some jiggling around).
7. Reverse steps to install carburetor.
8. Install new fuel filter in fuel line (be sure flow arrow is correct).

Used gaskets, fuel filter & heat shield as part of a carburetor freshen up on a MTD Yardman with Kohler 15 HP engine. Parts fit great, did have to trim the \"ears\" off the heat shield with a dremel tool to make the carburetor linkage clear...but that only took a minute & the old tractor fired right up & is running great!

I\ ... Read more 'll definitely use e-replacement parts again!

Be careful not to damage the small plastic insert from the throttle linkage on the carburetor and the other end of the throttle arm as these parts do not come with the kit.
To remove a carburetor and put a new one on is a easy job, will need a mm socket set. The engine on the lawn tractor started up first time with no problems.