Part Location Diagram of 36100-ZF6-P82 Honda Switch Assembly- Engine Stop
See part K-6 in the diagram
( Grid squares measure 1x1 inch )

Switch Assembly- Engine Stop 36100-ZF6-P82

Manufactured by:
Honda
ERP Number:
ERP9947048
Part Number:
36100-ZF6-P82
Original Equipment Manufacturer ?
  Works with your model  GX340RT1!
$23.93
Special Order

A Bit Difficult 

30 - 60 mins 

(1 rated repair) ?
  Works with your model   GX340RT1!

Product Description

?

A genuine item which is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. It is a high-quality replacement for a missing or damaged engine stop switch assembly which was originally installed on a new unit. Over time it may wear out and begin to fail eventually requiring a replacement, keep in mind this durable plastic body component is sold individually.

Troubleshooting

This part works with the following brands:
  • Honda
This part works with the following products:
  • Engine
  • Lawn Mower
  • Generator
  • Water Pump
Part# 36100-ZF6-P82 replaces these:
36100-ZH7-003,

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

A Bit Difficult 

30 - 60 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

switch starting to not shut off until I would wiggle it

Stephen from Potosi, Wisconsin

0 of 1 people found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set
Parts Used:
36100-ZF6-P82
1. undo wiring harness
2. unplug old switch wires
3. remove housing
4. bend back little tab holding switch on to housing
5. put new switch in and bend tab to hold in place
6. put housing back on
7. re-attach wire and wiring harness
Did you find this story helpful?
Thank you for voting!
  • 1