Part Location Diagram of 30700-ZE1-013 Honda Cap Assembly- Noise Suppressor
See part L-2 in the diagram
( Grid squares measure 1x1 inch )

Cap Assembly- Noise Suppressor 30700-ZE1-013

Manufactured by:
Honda
ERP Number:
ERP9937677
Part Number:
30700-ZE1-013
Original Equipment Manufacturer ?
  Works with your model  HS621!
$27.95
Special Order

Easy 

15 - 30 mins 

(1 rated repair) ?
  Works with your model   HS621!

Product Description

?

This replacement spark plug boot is an authentic component which is supplied by the original equipment manufacturer for use with Honda engines that are commonly installed on a variety of lawn and garden equipment. This rubber cap is used to connect the spark plug to the magneto, over time rubber material can dry out and crack eventually requiring a replacement. Please note this high-quality part is sold individually. Refer to the diagrams for your unit to ensure the correct repair procedure.

Frequently Purchased Together

?

Troubleshooting

This part works with the following brands:
  • Honda
This part works with the following products:
  • Engine
  • Lawn Mower
  • Generator
  • Snow Blower
  • Tiller
  • Water Pump
  • Lawn Tractor

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

15 - 30 mins 

(1 rated repair) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Broken spark plug boot and gummed carb

Jeremy from Gauley Bridge, West Virginia

5 of 5 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
1. Remove broken spark plug boot by pulling up.
2. Screw new boot on spark plug wire.
3. Place boot on spark plug.
4. Remove air filter.
5. Remove fuel line from carb using needle nose pliers.
6. Remove front two nuts from plastic cover.
7. Remove bolt on rear of plastic cover.
8. Remove cover.