This is a Genuine OEM Fuel Pump Replacement. It has a Plastic Body. A Fuel pump is used when the Fuel tank is mounted lower than the Carburetor and cannot rely on gravity to carry Fuel through the Fuel line. It is recommended to check for hairline cracks and other damage to the external surfaces of the pump. If it is damaged discard the pump and perform a fuel pump replacement.
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Mower repair
It's great to have one place to go to and be able to find parts for all your repairs around the house.
Sam - April 19, 2019
Verified Purchase
★★★★★
★★★★★
Easy repair
The parts worked out good and my pressure washer is working like new again
Esau - June 26, 2019
Verified Purchase
★★★★★
★★★★★
Thumbs up
My part came undamaged and it works, what more can you ask for.
Kenneth - September 9, 2019
Verified Purchase
★★★★★
★★★★★
Perfect fit
My generator was spraying fuel from the pump. The fuel pump I purchased was a perfect fit and cured my problem
Guest - April 6, 2020
Verified Purchase
★★★★★
★★★★★
Great part fit prrfectly.
Great service fast delivery.
Guest - April 6, 2020
Verified Purchase
★★★★★
★★★★★
great part and did the job. thanks
part was new as expected and came as was expected.
Guest - June 16, 2020
Verified Purchase
★★★★★
★★★★★
Entire fuel system was full of rust. I replaced the carburetor and fuel pump. Cleaned the tank and replaced the lines. It starts and runs like new.
Exact replacement fit. Works Great.
Guest - April 23, 2022
Verified Purchase
★★★★★
★★★★★
Quick repair
Thirty minutes after I received the fuel pump , carburetor and gaskets, it was back to work, parts came in perfectly marked and individual bags, .....shipping was adequate, and on time........ I know who to call the next time, I am down,
Thanks for your service
Guest - August 28, 2019
Verified Purchase
★★★★★
★★★★★
no problem works
arrived on time installed no problem
Guest - June 18, 2019
Verified Purchase
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
Be the first to ask our experts a question about this part!
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
1. Removed and replaced fuel pump. Still would not start.
2. Removed and disassembled carburetor. Cleaned and blew it out.
3. Reinstalled and it worked fine.
1. Removed two 10mm bolts.
2. Removed the air cleaner, the fuel hose, the throttle and the choke linkage as well as the tension spring.
3. Installed the new carburetor and the fuel pump.
4. Installed the linkage, the spring, the fuel hoses and the bolts.
5. Started the engine and made a small adjustment on the air/
... Read morefuel mixture screw.
Read less
Did you find this story helpful?
Thank you for voting!
11,000 watt generator powered by a 20hp Honda V-twin wouldn\'t start, used internet to diagnose problem was with the fuel cut-off solenoid valve.
John from Semmes, Alabama
3 of 3 peoplefound this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Engine would not start, had spark (engine would run when poured gas in Carb). Used Internet to diagnose and isolate the issue to the solenoid. When working properly, the gas cut off Solenoid valve will make an audible \"click\" when the key is turned, mine did not.
When removing the solenoid valve, be sure to used the right
... Read more size philips screwdriver, I didn\'t and buggered the head of one of the screws which caused me to remove the entire intake manifold and carburetor assembly. I then used vise grips to remove the screw.
It was good that I removed the entire assembly, I was then able to disassemble the carburetor and clean the contaminated gas and crud from the bowl, jet, etc. Fortunately the caskets and o rings were in good shape and everything went back together fine. Started instantly, I did install an easily accessible cheap fuel cut off in the fuel line ahead of the fuel pump in an effort to run the gas out when storing the generator....just need to pull it out and exercise the motor occasionally. Good luck
Removed the fuel tank, then removed defective fuel pump and installed new. Very simple taking less than half hour. Problem solved, no more fuel leak and engine fired right up.
Removed Carburetor and replaced the parts that where in bad shape
All I can say is that eREPLACEMENT got the parts to me fast with in 3 days that was great. I have used them before and have never had a bad deal with them. They are fast in shipping which is the best around as they get the parts to you. I recommend anyone needing par
... Read morets to check them out first before going any place else.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP17016324
Manufacturer Part Number: 16700-Z8A-004
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
(2007)_WW_17.gif "Part Location Diagram of 16700-Z8A-004 Honda Fuel Pump Assembly")
(2007)_WW_17.gif "Part Location Diagram of 16700-Z8A-004 Honda Fuel Pump Assembly")
