1. Remove three 10mm nuts to remove recoil starter and gas tank.
2. Remove kill switch wire and sparkplug lead.
3. Remove coil using 9mm and 10mm wrenches.
4. Reverse procedure to install. Used a business card to set air gap between coil and flywheel.
Did you find this story helpful?
Thank you for voting!
Ryobi pressure washer losing spark after running 5-10 minutes
Removed engine cover to gain access to ignition coil. Removed old coil and installed new coil. Set coil clearance gap using a business card between the coil and flywheel.
Did you find this story helpful?
Thank you for voting!
Engine still would not start - no apparent spark or just an intermittent spark. Gave up and working a replacement engine.
put on new ignition coil.
reassembled engine shroud
tried to start - no ignition
same problem as before
would not even pop with starter fluid sprayed into intake
gave up - working replacement engine
Fairly simple to repair with correct tools. Had to remove engine mounting bolts to spin and access the front as the frame encompassed the engine. Removed pull start assembly, removed and replaced part and gapped the new ignition coil. Reassembled and it fired right up. Many thanks to ereplacementparts for quick shipment and having the cor
... Read morerect part. They are my go to source !
Remove 3 nots that hold tank and pull cord.
Remove ground connection to coil.
Remove the 2 screws holding the coil.
Remove the coil
Install the new coil spacing it about 1/8\"
Reconnect all.
Followed instructions on a you tube video. Video did not show the correct alignment of coil. Initially installed upside down. Be sure to take picture of old one before removing.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP12131340
Manufacturer Part Number: 30500-Z8B-912
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
