Part Location Diagram of 91353-671-003 Honda O-ring-13.5 X 1.5-arai
See part G-6 in the diagram
( Grid squares measure 1x1 inch )

O-ring-13.5 X 1.5-arai 91353-671-003

Manufactured by:
Honda
ERP Number:
ERP10023702
Part Number:
91353-671-003
Original Equipment Manufacturer ?
  Works with your model  GX110!
$5.95
Special Order
Minimum Quantity of 2 required

Easy 

1- 2 hours 

(3 rated repairs) ?
  Works with your model   GX110!

Troubleshooting

This part works with the following brands:
  • Honda
This part works with the following products:
  • Engine
  • Generator
  • Lawn Mower
  • Snow Blower
  • Tiller
  • Water Pump
  • Lawn Tractor
Part# 91353-671-003 replaces these:
91353-671-004,

Questions & Answers

?

Our customer Service team is at the ready daily to answer your part and product questions.

Be the first to ask our experts a question about this part!

Ask our Team

We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.

Does this fit my product?

Customer Repair Instructions

All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.

Easy 

1- 2 hours 

(3 rated repairs) ?
  • 1
Sort by:  
Sorry, we couldn't find any existing installation instruction that matched.

Fuel leak

David from Carrollton, Illinois

3 of 4 people found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set, Wrench set
Removed fuel tank then unscrewed the old fuel joint and then screwed in the new fuel joint. No more leaks.
Did you find this story helpful?
Thank you for voting!

wasn\'t taken care of by owners help

JOHN from Enfield, Connecticut

1 person found this instruction helpful.
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers, Wrench set
check engine was worn out, purchase a long block, and all parts needed put together started up made adjustments and engine run\'s great.
Did you find this story helpful?
Thank you for voting!

My Honda HS 1132 Snow Blower Carburetor was leaking fuel.

Douglas from HAYDEN, Idaho

1 person found this instruction helpful.
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers, Screw drivers, Socket set, Wrench set
Although I own the Honda repair manual, it was of little help. I tried to find a video for this model on the internet, but could not find one for my HS 1132
Rather than try to figure out what was leaking, I just bought another carb and choke ass. It is not that expensive, compared to almost $4K for a new blower.
I carefully to ok photos with my cell phone at each step.
You must remove the shroud to get at the carb. After that, it was sort-of obvious what to do.
The choke cable is attached to the choke assembly with a circle clip that was a bear to remove and replace.
Take careful note of the several springs that must be removed and put back.
After assembly, the motor started on the first pull. No adjustments were required.

Did you find this story helpful?
Thank you for voting!
  • 1