It is made of metal and rubber and is sold individually. The solid state ignition connects to the spark plug cover and helps to generate the voltage used by the spark plug. During installation, a screwdriver and a socket set may be needed when replacing the ignition. This part is an OEM sourced directly from the manufacturer for use in engines and snowthrowers made by Tecumseh, Husqvarna, and Toro.
Disassemble top portion of housing area include simple lift out of gas tank. Rope pull housing also.magneto exposed . Magneto removed with 2 bolts. Magneto checked with digital meter coil to ground. Was internally shorted to ground. Reversed for assembly include simple 0.010 gapping of magneto with flywheel. Started second pull. I was thr
... Read moreilled! Then I had to mow......
Read less
Did you find this story helpful?
Thank you for voting!
The Solid State Ignition went out, there was no spark to the spark plug.
It looked like i had to pull the engine out but after looking at it really good all i had to do was remove the mounting bracket on the pulley side, there\'s work involved to get the job done, you have to remove the top cover and the back panel where the controls are, once inside to make it easier to replace the part you have to remove the
... Read more primer hose and unplug the ignition wires and then remove the crank cover, if you mechanically incline you shouldn\'t have any problems doing this type of repair, if you are not then I recommend taking it in to be repaired.
Removed spark plug wire from plug.
Removed 5 screws from pull start housing and removed it.
Removed 4 bolts from the magneto cover and removed the cover exposing the coil/lamination.
Checked the spacing between the coil and the magneto = .007 air space with feiller gauge.
Removed 2 screws holding the old coil and
... Read morereplaced with the new one.
Made sure there was .007 air space between the coil and magneto and tightened down the screws of the coil.
Reassemblied all previous parts.
The mower started on the second pull..
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP18503961
Manufacturer Part Number: TC-34443D
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
