This OEM approved overhaul kit is designed for rebuilding/fixing carburetor on a Briggs and Stratton engine. This kit contains all the necessary gaskets, diaphragms and other parts to rebuild your carburetor. It helps to fix common problems associated with worn out gaskets or diaphragms, including leaks and sluggish performance and other related issues. Replacing these items you would need a screwdriver and pliers.
Determined that the engine was not getting enough gas. removed all of the linkages attached to the carburetor and then removed the carburetor from the engine. Disassembled the carburetor, used an aerosol carburetor cleaner to clean the parts, then scraped off all of the old gasket material that was left on the carburetor. Used a small o-r
... Read moreing pick to remove the old needle seat. Again, using the aerosol cleaner, cleaned the opening making sure no particles from the old seat were left there. installed the new seat, (this was a Briggs engine, so the side of the seat with groves went into the carburetor first), installed the new needle valve and float (reused the old float), reassembled the carburetor. Installed the new spacer and carburetor on the engine and attached all of the linkages. Cranked the engine, it started and would run and idle with the choke completely off. This repair was completely successful.
Removed the carb from the engine and clean real good. Replace parts with the rebuilt kit put carb back on and started the engine after a few pulls runs great.
Remove valve cover and clean real good and replace gasket, put back on ran engine after warn up check tightness of bolts noleaks
1. Removed carb. 2. Changed parts that were included in the kit. 3. Took carb cleaner and sprayed every hole and part I could. 4. Runs better but still has to have choke on. ???
Worked my way down to the carb.
Took it apart and cleaned with carb spray cleaner
Tried to insert rubber valve seat but didn\'t fit,
Noticed that valve wasn\'t same as one from carb which has rubber at cone end, so I cleaned that one up and used it instead.
Found three of the gaskets that matched, and reassembled
... Read more.
The only parts I used after spending over $30 were three gaskets.
Runs fine. Don\'t know what went wrong. I matched the model number off engine. Maybe they used a different carb.
Anyhow, it blows snow.
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9306689
Manufacturer Part Number: 792006
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
