Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Shipping Was Fast
Even though I was notified of a potential delay my replacement part was shipped quickly and I was able repair my lawnmower the following weekend. I would reccomend this website for future replacement parts.
Guest - May 15, 2020
Verified Purchase
★★★★★
★★★★★
Home owner
As usual ya'll saved the day. Parts work installation easy. Trying to keep this old troybilt alive, thanks again.for you help ..
William - April 21, 2021
Verified Purchase
Customer Repair Instructions
All our customer repair instructions are solicited directly from other customers just like you who have purchased and replaced this exact part.
A Bit Difficult
1- 2 hours
(4 rated repairs)?
< Prev
1
Next >
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Rope had been replaced but not with original equipment, ie rope too short
Removed gas tank.
Removed recoil housing
Pulled old rope to fully extended
Placed screw driver thru holes to hold recoil in fully extended position
Removed old rope and installed new rope
Reinstalled recoil housing
Reinstalled tank
Did you find this story helpful?
Thank you for voting!
very little compression ex. valve leaked
Hans from ARLINGTON, Texas
3 of 3 peoplefound this instruction helpful.
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
Completely disassembled engine cleaned all parts and repainted
honed the cylinder, regrind both valves
reassembled all parts by changing out all ordered parts.
1 Remove starter housing
2 Pulled rope all the way out and held fully extended
3 Cut knot on old rope and discarded it then threaded new rope with handle installed, tied knot and let the rope slow retract in
4 Place new stop in to position and crimped on to rope.
5 Take plastic cover of drive belt( 1 screw on mi
... Read morene) remove bolt that hold cable then remove and replaced traction cable, adjusted to proper position to engage drive belt. after complete put cover back over drive belt
Very simple repair, just need to pay attention to how you disassemble to make sure everything aligns with out interference.
Handle knobs just remove old one and spin new ones on.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
