Gasket-cylinder Head 796475

remove all covers and whatever is in the way to access 4 head bolts
remove 4 head bolts, remove head gasket and push rods
they want you to use new head bolts I did not.
remove old gasket material
replace head gasket and reinstall head and push rods
torque 4 head bolts to 22 ft pds. yes 22 foot pounds in a cro ... Read more ss pattern.
carefully put your push rods back under rocker arms, be sure both ends of the push rods are seated where they belong.
turn the flywheel by hand to see all that stuff is working as it should
be sure your gasket for your rocker arm cover is good and install that after you check valve clearance
both valves set at .004 intake and exhaust yes .004
put all the other stuff back on and start your engine.
cut your grass it is too tall!!!!!

Remove carb, muffler,flywheel cover, flywheel and engine head, check for damage to valves and piston, clean cylinder head and top of piston, replace head gasket and head, adjust valves to manufactures specs, replace carband other parts that were removed, sounds complicated but it`s really not.