This replacement clamshell set is specially designed for use with Dewalt drills. It is an authentic item that is sourced directly from original equipment manufacturer. This set contains both the left and the right sides of the housing, please note the hardware that hold the clamshell together is sold separately. This clamshell set is made from durable plastic and it is sold individually.
Troubleshooting
This part works with the following brands:
DeWALT
This part works with the following products:
Electric Drill
Cordless Drill
Questions & Answers
?
Our customer Service team is at the ready daily to answer your part and product questions.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Ask our Team
We have a dedicated staff with decades of collective experience in helping customers just like you purchase parts to repair their products.
Removed one half of assy. housing, cleaned that side of motor and installed that side of the housing. The removed other broken half and cleaned that side of motor. Installed other side of housing and paddle assy. Put new screws in and attached label. Ops. checked ok.
The wires coming off the forward/reverse switch are tricky to get right or the switch will bind and not operate properly. There are slots, very hard to see, in each side of the clamshell that the switch wires MUST run through. Just putting the two halves together does not do it. I needed to use a little hooked dental tool to go in through
... Read more the battery opening to work the wires into the grooves/slots to get the shells to close straight enough for the switch to not bind. If you can look up their before you take the old one off you can see what I mean.
Remove the battery
Remove the screws from the housing
Separate housing trying to keep all the parts in one side
Take a picture to show where all the parts go
Transfer the parts from the old housing to the new housing
Make sure the parts are in their correct spot
Put the new housing together
Start by removing the screw that connect the two housing halves together. Remove one housing half. Take a pictures of all the parts in their place. Carefully remove the internal parts of the drill into one of the new handle halves. Revering back to the pictures. Once you have the parts in the new housing half. Assemble both halves togethe
... Read morer, and make sure it is a proper fit. Install the screws. Then test the drill.
Read less
Did you find this story helpful?
Thank you for voting!
Dropped on concrete too many times and base had cracked and broken.
Remove battery and all screws, remove that half, install new half, turn over and repeat. Make sure both sides are fully connected, ensure drill works, install screws and done.
Very easy to replace, 5 screws and case came apart. Take a picture of where the internal parts are located. Remove internal parts and put in new case. Reinstall 5 screws and your done.
Did you find this story helpful?
Thank you for voting!
< Prev
1
Next >
✖
Stock Status
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
